[. . . ] The manufacturer is not responsible if an incorrect installation and use causes injuries and damages. €¢ Make sure not to cause damage to the mains plug and to the mains cable. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Centre. €¢ Connect the mains plug to the mains socket only at the end of the installation. [. . . ] The use of this option decreases the energy consumption (up to 25%) and the programme duration. €¢ If the option is not applicable to the programme, the related indicator does not come on. 3 Acoustic signals The acoustic signals operate when the appliance has a malfunction or when the adjustment of the level of the water softener occurs. There is also an acoustic signal that operates when the programme is completed. By default, this acoustic signal is off, but it is possible to activate it. Press and hold, at the same time, Program and Option for a few seconds. 2 Multitab Activate this option only when you use the combi detergent tablets. Press and hold, at the same time, Delay and Start until the programme indicators , and start to flash. Press the on/off button to deactivate the appliance and to confirm the setting. Make sure that the set level of the water softener agrees with the water hardness in your area. Contact your local water authority to know the water hardness in your area. ENGLISH 57 You must adjust the water softener manually and electronically. Manual adjustment Turn the water hardness dial to the position 1 or 2. Press and hold, at the same time, Program and Option for a few seconds. Press and hold, at the same time, Delay and Start until the programme indicators , and start to flash. €¢ The display shows the current setting of the water softener. Press the on/off button to deactivate the appliance and to confirm the setting. Fill the rinse aid dispenser (A), no more than the mark 'max'. Remove the spilled rinse aid with an absorbent cloth to prevent too much foam. You can turn the selector of the released quantity (B) between position 1 (lowest quantity) and position 4 or 6 (highest quantity). €¢ If the rinse aid indicator is on, fill the rinse aid dispenser. Set and start the correct programme for the type of load and the degree of soil. [. . . ] 2 How to activate the rinse aid dispenser The activation of the rinse aid dispenser can occur only with the Multitab option activated. Press and hold, at the same time, Program and Option for a few seconds. Press and hold, at the same time, Delay and Start until the programme in, dicators start to flash. Press the on/off button to deactivate the appliance and to confirm the setting. [. . . ]